INSTALLATION GUIDE FOR DIE-CUT DECALS
Follow the instructions to install the decal. The instructions described below refer to the dry method. If you are inexperienced or are installing a large decal, the wet method is recommended. To apply this method, once the surface is clean, spray detergent or baby shampoo water on the installation surface, then continue to step 1 of this guide. With this method, air bubbles are less likely to remain, even allowing you to reposition the decal.
What is needed?
Alcohol or soapy water, paper towels, adhesive tape, squeegee, needle, cutter or scissors.
Preparation
Using alcohol or soapy water clean the surface thoroughly and let it dry. For better results low humidity levels and outside temperatures over 65ºF are recommended.
You have received a set consisting of three layers: 1 Top layer: transfer tape; it keeps the decal in its place for a better installation; 2 Middle layer: the die-cut decal; 3 Bottom layer: waxed paper protection back.

Installation
[1] Place the set on a clean, flat, and even surface; with the layer 1 facing you.
Note: slide the squeegee firmly over the surface to ensure better adherence between layers. Repeat a few times in various directions.

[2] Find the central spot or desired location to install the decal. You can help yourself with a metric tape, ruler or any reference mean.
[3] Place the set against the surface where it will be installed, with layer 1 facing you. Fix the set to the surface using a strip of adhesive tape in the middle and throughout the piece, as well as in its four corners.

[4] Pick one of the corners and peel off the transfer tape gently and slowly; then separate the layer 3 in a 45º angle to avoid deformations or tears. Stop when arriving to the central line marked by the adhesive tape; pressing both the decal and tape while cutting and removing the loose waxed protection paper. You can use a cutter, scissors or tearing the paper with your hands as clean as possible.

[5] Carefully place the exposed area of layer 2 against the installation surface and slide the squeegee firmly over layer 1, with center-to-edge movements. The squeegee should remain in contact with decal area as much as possible to avoid air bubbles.

[6] Once the first half is installed, take off the middle adhesive tape used to fix the set in its position, then repeat steps 4 and 5 to install the other half of the decal.
[7] At this point the decal should be completely on the surface. With certain pressure, slide the squeegee firmly over the transfer tape in the decal area vertically and horizontally.
[8] If you applied the wet method, depending on the temperature, wait to allow the decal to dry and adhere securely to the surface. If you applied the dry method instead, carefully remove the entire layer 1 at a 45º angle. Be careful; doing it too fast can damage the material. Once the installation is completed, only the decal should remain on the surface.

If there are air bubbles, most of them can be pushed to the edges with the squeegee. If they are not totally removed this way; use a cutter to do a small incision and expel the air by pushing gently with your finger. Full cure time for the decal is between 4 to 8 days. Do not use any cleaning products on the surface until the decal has completely cured.
